Pages: [1]   Go Down
Author Topic: avrdude: stk500_getsync(): not in sync: resp=0x00  (Read 658 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Jr. Member
**
Karma: 0
Posts: 74
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I recently purchased an Arduino UNO Bootloader chip from DIgikey and am using an FTDI chip TTL-232R-5v cable connected up as follows:

FTDI Cable Pin:
1 - Ground
2 - Ground
3 - +5V (arduino pins 7 & 20)
4 - Arduino D0 (pin 2)
5 - Arduino D1 (pin 3)
6 - open

I also have a 100k pullup on the reset line (pin 1)
and an LED tied high connected to D13 via a 400 ohm resistor.

I am using the arduino 1.0.1 suite and have selected the board type as Arduino Duemilanove w/ ATmega328
and when I compile and upload, the LED on D13 does not flash unless I manually toggle the reset line and it only flashes briefly
not like it would if it was uploading code.

When the upload is complete I get the message:   avrdude: stk500_getsync(): not in sync: resp=0x00

What am I doing wrong and how do I correct this?

thanks
Logged

California
Offline Offline
Faraday Member
**
Karma: 88
Posts: 3368
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am using the arduino 1.0.1 suite and have selected the board type as Arduino Duemilanove w/ ATmega328

Why aren't you selecting the Arduino Uno board?
Logged

Pages: [1]   Go Up
Jump to: