Go Down

Topic: avrdude: stk500_getsync(): not in sync: resp=0x00 (Read 740 times) previous topic - next topic

irethedo

I recently purchased an Arduino UNO Bootloader chip from DIgikey and am using an FTDI chip TTL-232R-5v cable connected up as follows:

FTDI Cable Pin:
1 - Ground
2 - Ground
3 - +5V (arduino pins 7 & 20)
4 - Arduino D0 (pin 2)
5 - Arduino D1 (pin 3)
6 - open

I also have a 100k pullup on the reset line (pin 1)
and an LED tied high connected to D13 via a 400 ohm resistor.

I am using the arduino 1.0.1 suite and have selected the board type as Arduino Duemilanove w/ ATmega328
and when I compile and upload, the LED on D13 does not flash unless I manually toggle the reset line and it only flashes briefly
not like it would if it was uploading code.

When the upload is complete I get the message:   avrdude: stk500_getsync(): not in sync: resp=0x00

What am I doing wrong and how do I correct this?

thanks

Arrch


I am using the arduino 1.0.1 suite and have selected the board type as Arduino Duemilanove w/ ATmega328


Why aren't you selecting the Arduino Uno board?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy