I just got my nano v3.0 and I'm excited to start working with it. Unfortunately it came without a bootloader installed. Now I'm trying to figure out how to burn the bootloader onto my nano by using the uno rev3 I have as an arduinoISP.
I think I understand all the steps I have to do in the IDE, but I'm not sure about the connections I made.
I connected pins 11,12,13 from the uno to the nano, I connected pin 10 from the nano to the reset of the uno, I put a 10µF capacitor from reset to GND on the uno. I should also mention that I'm powering the nano with a USB cable connected to my pc (so, not using the power pins from the uno).
I then get this error:
avrdude: Send: P  
avrdude: stk500_program_enable(): protocol error, expect=0x14, resp=0x50
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
avrdude: Send: Q  
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51
avrdude done. Thank you.
I'm guessing I just don't have everything wired the way I should. Can anyone help me out here?