Go Down

Topic: bootloading atmega8 (Read 431 times) previous topic - next topic

vikirobot

hi
iam trying to bootload my atmega8 using usbasp programmer. but arduino IDE showing the error "expecting device signature 1E atmega328"
why it is asking for atmega328 when iam trying to bvootlad atmega 8?


another question is how to map the pin in bread board  assembled arduino refering  with original uno board?

is it possible to upload sketch in to my  bread board  assembled arduino  using USBASP programmer from IDE?

Nick Gammon

I think my bootloader programmer handles the Atmega8:

http://www.gammon.com.au/forum/?id=11635

The wiring would be the same as for the Atmega328.

Also see: http://www.gammon.com.au/breadboard
Please post technical questions on the forum, not by personal message. Thanks!

More info:
http://www.gammon.com.au/electronics

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy