Pages: [1]   Go Down
Author Topic: Existing LED Board Design Question  (Read 338 times)
0 Members and 1 Guest are viewing this topic.
Vancouver BC, Canada
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am hoping that someone here can help me with a simple design question?
I have the following LED board that came out of a LED lamp, it has an array of 2x4 LEDs on it at the bottom, I was going to wire it up directly into a power source, but then I started looking at it and I cannot for the life of me understand why there is two transistors at the top. They are not switching on any larger power source so why have them there and run the power through them? I have attached a picture of the back of the board with some notes on it in the hopes that someone can tell me why they are on there?

Thanks
Chris


* led board.jpg (153.29 KB, 910x951 - viewed 29 times.)
« Last Edit: November 05, 2012, 10:29:46 pm by Chris7777 » Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 62
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think this may be relevant, .
Logged

Pages: [1]   Go Up
Jump to: