Pages: 1 [2]   Go Down
Author Topic: How is this Mega proto shield wired?  (Read 5417 times)
0 Members and 1 Guest are viewing this topic.
Central MN, USA
Offline Offline
Tesla Member
***
Karma: 72
Posts: 7171
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Nick,
You will have to solder wires on the back side to make connections, kind of pain in the butt. Just fancy strip board. You can also use wire wrap compatible parts to wire wrap. I never understood why these arduino proto shields have these holes.
Logged


Pages: 1 [2]   Go Up
Jump to: