Pages: [1]   Go Down
Author Topic: Serial.print in void setup()  (Read 324 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 1
Posts: 64
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

At times the serial.print does not print. This only happens when the code is in setup().
Have put in a delay after serial.begin to no avail.
When I hardware reset, the serial.print in setup() displays ok.

Is there a software reset that I can code in void loop()


Global Moderator
Melbourne, Australia
Offline Offline
Brattain Member
Karma: 511
Posts: 19350
Lua rocks!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Read this before posting a programming question

Your code?

Please post technical questions on the forum - not to me by personal message. Thanks a lot.

Pages: [1]   Go Up
Jump to: