Go Down

Topic: Arduiono UNO "holder" (for want of a better term) (Read 1 time) previous topic - next topic

Graynomad

Nov 07, 2012, 09:26 am Last Edit: Nov 07, 2012, 10:43 am by Graynomad Reason: 1
Anyone seen these before? Quite clever I thought.



I think they a just a short run because they are 3D printed, but I like the idea and done in a material that's just a bit flexible and grippy I think they would be very useful to keep pins off the bench and stop the board sliding around with every moved cable.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

liudr

Neat. Yeah, I thought about 3D-printing a case. Too expensive.

Graynomad

Quote
Too expensive.

Yeah, but as a moulded product it would be cheap. Expensive setup though I guess.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

kf2qd

Hmmmm... A couple pieces of Aluminum and some rtv silicone...

liudr

I laser cut face plates and some times I have some space I will add a design such as a support for arduino. It's a planar thing, not snap on or anything.

Go Up