Go Down

Topic: Connecting an Atomic 6DOF IMU to ARDUINO Uno (Read 810 times) previous topic - next topic

Fettahoglu

Dear All,

I've just bought an Atomic 6DOF IMU sensor from Sparkfun and also an Arduino Uno Board.

I want to connect this IMU to my Arduino and get the raw data, but I couldn't find an instruction about how to connect them.

My first question; Is Arduino UNO capable to get data from this IMU?

If it's possible;

There are six pins on my IMU sensor;

1- GND (for ground)
2- Bulk (no name)
3- VCC
4- RXD
5- TXD
6- OTR

How should I connect these pins onto the Arduino? To ANALOG IN sockets or where?

Thank You all in advance for Your help!

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy