Pages: [1]   Go Down
Author Topic: FSR instead of Hall Sensor (Throttle Pedal)  (Read 584 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Dear Friends,

I would like to replace an accelerator/throttle pedal on a vehicle (for disabled people) with Force Sensitive Resistor, searched examples with Force Resistive Sensor and Arduino but could not find any suitable circuit. The original throttle pedal have hall sensor in it and when i read values with a scope and multimeter, the analog outputs of original part as following :

Pin 1 - Unpressed : 0.405 Volt
Pin 1 - Pressed : 0.458 Volt
Pin 3 - Unpressed : 0.204 Volt
Pin 3 - Pressed : 0.652 Volt

I have also figured out that a force of 0 to 1000 gr is applicable for this type of sensor.

All of the examples ( are with Op-amps but i would like to make it with Arduino so i would like to have a configurable setting for any voltage between 0 to 5V (eg: from 0.204V to 0.652V).

Any ideas and helps are appreciated with circuit design / code etc.
« Last Edit: November 27, 2012, 11:04:32 am by esingd » Logged

Global Moderator
Offline Offline
Shannon Member
Karma: 224
Posts: 13915
In theory there is no difference between theory and practice, however in practice there are many...
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

you can set the ANALOGREFERENCE to 1.1Volt that should be enough to notice the differences.

read - -


Rob Tillaart

Nederlandse sectie -,77.0.html -
(Please do not PM for private consultancy)

Pages: [1]   Go Up
Jump to: