Go Down

Topic: MATLAB Stepper Nano Problems (Read 280 times) previous topic - next topic

Hello All,

I cannot seem to get my Matlab software to control my hardware:

http://www.gravitech.us/2mwfecoadfor.html
http://www.arduino.cc/en/Main/ArduinoBoardNano

1. If I get a solid connection after loading a .pde file and installing a the Afmotor library on the nano and all I get is a large printout saying that the Arduino was successfully connected to MATLAB, but the pins are unassigned, how do I assign those darn pins?

int motorpin1(6) or something? and if so wont I delete the whole motorsrv.pde file form the board that made a connection to mat-lab even possible?

2. Do I need to alter the motorsrv.pde file that I found on the MATLAB support I/O pack in order to suit the Nano or are they fine for all boards, driveshield and steppers?

PLease EMail me or respond to this !



kbmcmorrow @ gmail

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy