Go Down

Topic: connection diagram order to arduino lcd j12864 - pedido de diagrama de coneccion (Read 5976 times) previous topic - next topic


i have the same problems! I have an arduino mega and also de graphic lcd j12864 and i don't know how to connect them! I downloaded the ug8 library but i think my problem is hardware. I just don't know how to connect the lcd to the arduino.


RST to Digital Pin 5
E to Digital Pin 4
R/W to digital pin 3
RS to digital pin 2

Other pins as described in the datasheet or the controller manual of the ST7920.

Then use:

Code: [Select]
U8GLIB_ST7920_128X64 u8g(4, 3, 2, U8G_PIN_NONE, 5 );

Pin numbers above are only suggestions, you may use any valid digital pin.



thanks. I did what you say, but i still get nothing in the lcd.
I connected the pins as you said, also de vcc and ground, but the lcd didn't turn on.
I'm using the ug8 library and trying to do the example "Hello world"... I still get nothing and i'm getting angry! ja
thanks for your support!


Maybe you can post a picture of your setup, so that we can have a look at it.


Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131