Go Down

Topic: Due pinout diagram (Read 247562 times) previous topic - next topic

Armindo

Very good!!! Thanks a lot.

polysysdelta


salaideva

will you please point where is the clock(84 MHz)? :smiley-eek:

Graynomad

There is no external 84MHz clock AFAIK, I think you can put a clock signal out a pin but I doubt it would be the full 84MHz, maybe but that would be such an uncommon requirement I don't think it's needed on the diagram.

Also running 84MHz out to those headers would be an exercise in futility I suspect,

If it exists I'm willing to listen to arguments though.

______
Rob
Rob Gray aka the GRAYnomad www.robgray.com

spicetraders

THX, just received my first DUE, sadly it is not working but will get another to replace.

Vaclav

It may have been noted - but...

Is is possible that I2C ports SAM designations port numbers only are reversed?
SCL1 reads  TWCK0
SDA1 reads  TWD0 

and the "no number" I2C SAM designators are TWCK1 and TWD1
"Thunder is good, thunder is impressive; but it is lightning that does all the work"
Mark Twain

I do not read nor respond to thunderous posts.

cdan

Rob Gray, you saved me a great deal of time.
Excellent job, thx.

Vaclav

Very minute / minor observation
The "TX" LED ( below USB native port ) is green, not yellow as shown on schematic.
"Thunder is good, thunder is impressive; but it is lightning that does all the work"
Mark Twain

I do not read nor respond to thunderous posts.


Wurstnase

#159
Apr 26, 2015, 11:23 pm Last Edit: Apr 28, 2015, 07:34 pm by Wurstnase
Great job!

tsester

Thanx a lot for the diagram :)

SicongLiu

Can I use the internal resistors of pin14~19 by pinMode(pin,INPUT_PULLUP)? Does DUE has internal resistor on these pins?

_pepe_

#162
Jul 15, 2015, 03:30 pm Last Edit: Jul 15, 2015, 03:32 pm by _pepe_
Can I use the internal resistors of pin14~19 by pinMode(pin,INPUT_PULLUP)? Does DUE has internal resistor on these pins?
Yes, you can activate internal resistors on these pins.

sinq

sinq

MrAl

Hi,


One of the best diagrams i have seen so far for just about any micro controller.  Very clear and well laid out, easy to see where everything goes and where everything comes from.


Thanks.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy