change the places from PWMH2 and CANTX1
Thanks Stimmer.I've changed the colour of the port pins. As it's important this is legible in hard copy can you print it out again and see if that's now the case? Note that at present I'm limiting the size to 2000px wide, this should print well up to about 8" or even A4 without pixelization. When it's more stable I'll upload larger versions.I've added the LEDs.But I'm having trouble with your second point. I can see that D10 and D77 are the same pin, IE C.29 or SS0/PWM10. But I can't see that any LED is connected to this. I don't have a Due so can't check this, which LED blinks?New version uploaded with the above as I see it so far._____Rob
TX0 RX0 may for USB programming isn'd obvious
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16