Go Down

Topic: Driving A 10x10x10 RGB Cube (Read 7831 times) previous topic - next topic


For background reference, I happened to chance upon this website,


This video shows pretty good POV,



Nov 17, 2012, 09:13 pm Last Edit: Nov 17, 2012, 10:06 pm by fungus Reason: 1

I'm planning to use an external flash chip

Isn't flash slow?

For writing? Maybe...

For reading? My datasheet says the chips accept 66mHz SPI clock during reads - far higher then anything an Arduino can manage!

(OTOH if you've got 19 TLC5940s to drive with SPI there might not be much SPI bandwidth left over...)
No, I don't answer questions sent in private messages (but I do accept thank-you notes...)

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131