Pages: [1]   Go Down
Author Topic: FTDI for Uno diagnosis  (Read 434 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
**
Karma: 0
Posts: 69
Arduino Rocks!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi people! I have an Arduino Uno rev3 which I think I fried well! When I plug it to my computer, the Rx/Tx leds do not blink and no /dev/ttyACMX appears - dmesg reports no events when I plug in the board.

It happens that I have an FTDI breakout that maybe I can use to check whether my Arduino board is indeed damaged. The strange thing is that the program that I had previously burnt (burnt... ironic!) on the chip, is still running perfectly fine; of course this doesn't suggest that the chip is partially damaged.

My question is whether I can use my USB2Serial board and check whether I can program the AVR328P chip. I plugged in the USB2Serial board and at least this works. There must be a way to program the chip with the FTDI... Should I remove it from the board?
Logged

An Arduino development board costs €20~60. A pack of 20 Zener diodes to protect your board from almost certain damage costs less than €1...

SE USA
Offline Offline
Faraday Member
**
Karma: 41
Posts: 3783
@ssh0le
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

yes, pins 2 and 3 on the chip are TTL level rx and tx just like the ftdi, personally I would pop the chip from the arduino and use a breadboard so if anything is fried outside of the chip it wont interfere.

http://www.arduino.cc/en/Hacking/PinMapping168

if it doesnt work at first try crossing RX and TX, thats always a pain in the butt with serial
« Last Edit: November 14, 2012, 12:58:59 am by Osgeld » Logged


Pages: [1]   Go Up
Jump to: