Go Down

Topic: FTDI for Uno diagnosis (Read 521 times) previous topic - next topic

chung

Hi people! I have an Arduino Uno rev3 which I think I fried well! When I plug it to my computer, the Rx/Tx leds do not blink and no /dev/ttyACMX appears - dmesg reports no events when I plug in the board.

It happens that I have an FTDI breakout that maybe I can use to check whether my Arduino board is indeed damaged. The strange thing is that the program that I had previously burnt (burnt... ironic!) on the chip, is still running perfectly fine; of course this doesn't suggest that the chip is partially damaged.

My question is whether I can use my USB2Serial board and check whether I can program the AVR328P chip. I plugged in the USB2Serial board and at least this works. There must be a way to program the chip with the FTDI... Should I remove it from the board?
An Arduino development board costs €20~60. A pack of 20 Zener diodes to protect your board from almost certain damage costs less than €1...

Osgeld

#1
Nov 14, 2012, 06:57 am Last Edit: Nov 14, 2012, 06:58 am by Osgeld Reason: 1
yes, pins 2 and 3 on the chip are TTL level rx and tx just like the ftdi, personally I would pop the chip from the arduino and use a breadboard so if anything is fried outside of the chip it wont interfere.

http://www.arduino.cc/en/Hacking/PinMapping168

if it doesnt work at first try crossing RX and TX, thats always a pain in the butt with serial
http://arduino.cc/forum/index.php?action=unread;boards=2,3,4,5,67,6,7,8,9,10,11,66,12,13,15,14,16,17,18,19,20,21,22,23,24,25,26,27,28,29,30,86,87,89,1;ALL

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy