Pages: [1]   Go Down
Author Topic: Motor Control  (Read 933 times)
0 Members and 1 Guest are viewing this topic.
USA
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello, I would like to control 4 motors independently.  I am planning on using motors from VEX 2-Wire Motor 393 (http://www.vexrobotics.com/products/accessories/motion/276-2177.html) without the controller module things.  I need to be able to vary the magnitude of the motors independently of each other and also that means be able to reverse the direction of the motors.  I noticed that Stall Current:4.8A and Free Current:0.37A.

Basically my question is what should I use to do this?  Do I need Motor Drivers or Motor Controllers or what?  If someone could recommend a board for the motors I linked above that would be awesome!!!
Logged

Offline Offline
Edison Member
*
Karma: 26
Posts: 1339
You do some programming to solve a problem, and some to solve it in a particular language. (CC2)
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Adafruit industries has a nice motor shield that supports up to 4 bi-directional dc motors, but I think its current rating is too low for you...

"4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes. Can run motors on 4.5VDC to 25VDC."

Anyway here it is:

http://www.adafruit.com/products/81

my 2 cents.
Logged

USA
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks!  I was thinking about using that one but like you said I'm not sure about the current.  I got the larger of the motors because for my application the motors cannot stall so I figured I wouldn't need to worry about the stall current right?
Logged

Offline Offline
Edison Member
*
Karma: 26
Posts: 1339
You do some programming to solve a problem, and some to solve it in a particular language. (CC2)
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I think you should play safe in case motors _do_ stall. You don't want to accidentally fry the h-bridge (or burn your fingers...) if the unexpected happens, right ? Because everybody knows it _does_ smiley
Logged

United Kingdom
Offline Offline
Tesla Member
***
Karma: 223
Posts: 6593
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

L293D H-bridges are definitely not suitable for this application. This http://www.pololu.com/catalog/product/2503 is probably adequate.

Even if you never stall your motors, they will draw the stall current when you power them up, unless you power them up very gradually with PWM at a sufficiently high frequency.
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Pages: [1]   Go Up
Jump to: