Go Down

Topic: connect arduino mega 2560 to arduino uno rev 3 (Read 446 times) previous topic - next topic

jessie08

Hello everyone! Is it possible to connect arduino mega 2560 to arduino uno rev 3? Let us say I am going to use mega as the main controller. If yes, I wish you can tell me how. Thank you

KeithRB

However you want. I prefer serial, but there is always SPI or two-wire interface. Actually communicating is up to you. 8^)

CrossRoads

Can be simpler too - just writing an output pin hi or low. Evertytime the Uno sees the pin change it does something,
Really depends what you want the Uno to do.
If its more complex, like turn on LED #4 for 7 seconds, then some form of serial comm's would  be good - UART, SPI, I2C, software serial.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Go Up