Loading...
« previous topic   next topic »
Pages: 1 2 [3]   Go Down
Author Topic: Driving A 10x10x10 RGB Cube  (Read 1473 times)
0 Members and 1 Guest are viewing this topic.
oric_dan
the land of sun+snow
Offline Offline
Edison Member
*
Karma: 81
Posts: 2123
View Profile
WWW
« Reply #30 on: November 17, 2012, 01:41:35 pm »
 Bigger Bigger Smaller Smaller Reset Reset
For background reference, I happened to chance upon this website,

http://channel9.msdn.com/Tags/electronics/RSS

This video shows pretty good POV,

http://www.youtube.com/watch?feature=player_embedded&v=GUcX41pokZY
Logged
Kitchen-Sink Arduino-compatible boards

fungus
Valencia, Spain
Offline Offline
Edison Member
*
Karma: 65
Posts: 2251
View Profile
« Reply #31 on: November 17, 2012, 03:13:24 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Quote from: P18F4550 on November 17, 2012, 09:24:14 am
Quote
I'm planning to use an external flash chip
Isn't flash slow?

For writing? Maybe...

For reading? My datasheet says the chips accept 66mHz SPI clock during reads - far higher then anything an Arduino can manage!

(OTOH if you've got 19 TLC5940s to drive with SPI there might not be much SPI bandwidth left over...)
« Last Edit: November 17, 2012, 04:06:24 pm by fungus » Logged

Pages: 1 2 [3]   Go Up
Print
« previous topic   next topic »
 
Jump to: