Go Down

Topic: PWM LED letter V tail light (Read 1 time) previous topic - next topic

metalman3797

I am starting to design a LED tail light for my motorcycle.  I want the tail light to be 2 V's one both on at X amount of brightness when the bike is on and when the brakes are applied 100% brightness.

I am new to arduino and tried to look around but couldnt find anything specific.  How would would i make that work through the arduino?  I assume PWM.  The bike uses 250ma/12v running and 500ma brakes applied from what i see with the current single LED (stock)

One cool thing i would like it to do is do a sequential effect starting at the bottom of the V and go to the top then start over again.

So when stopping it would sequence 3 times then stay on untill brake is released
When using the left/right signal, the V would sequence from bottom to top on the left or right.

Any help would be awesome! :)  Currently using an arduino uno r3

Boffin1

You could wire the LEDs in batches of four ( gives about 8v for normal red LEDs) in series with a small driver transistor,  and connect each of the ten drivers to a pin of the R3.

You would need 4 inputs from the light/indicator switches, and simply generate a series of output patterns with suitable delays and pwm.

I would however ( if it were legal to do this anyway )  have most of the LEDs on, and rather create a blank dot moving up the V, to give more light output - especially the brake light.

metalman3797

I actually wasnt clear with that.  The Led's would always be on the low setting always and then would sequence to the full brightness.

The sequence would sequence the left/right side of the V
It would be similar to a sequence like this.  Bottom to the top then start again.
 
o  o     o  o     o  o
o  o     o  o     o  o
o  o     o  o     o  o
o  o     o  o     o  o
o  o     o  o     o  0
o  o     o  0     o  0
o  0     o  0     o  0

Boffin1

The way I see it is 9 blocks of 4 leds,  starting with A at the top left , going down to E at the bottom and back up to I at top right.
Set each chosen pin to output.

You cant pwm all the output pins, but you could have one loop with the selected LEDs on, and one ( or more )with them all off for dim.

With no switch inputs,  you can have various functions for whatever switches are operated, 

A ( long winded ) pattern for all LEDs on might be
digitalWrite ( A,HIGH );
ditto B CDEFGH // as above
digitalWrite ( I,HIGH );







metalman3797

Is there a more efficient way of of doing this?  it doesnt necessarily need to follow my schematic wiring  as long as it can do what i described in the first 2 posts.

I appreciate any help.  I am still very new and trying to learn.

Is there also a site where you can ash people to write the code for free or compensation?

dxw00d

Quote
Is there also a site where you can ash people to write the code for free or compensation?


The Gigs and Collaborations forum - http://arduino.cc/forum/index.php/board,26.0.html

metalman3797


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy