Go Down

Topic: ATmega328P I2C, SPI to XBee & I/O expander? (Read 1 time) previous topic - next topic

BlueBill

I'm connecting an ATmega328P, PIC18F26J11 or Rasberry Pi to an I/O extender and I've attached my current I/O map.
The I2C is a SC16IS750 8 bit + UART I2C expander with an interrupt and reset.
RS485/232 is a mode pin set by DIP switch on a MAX3160 (the half/full duplex pin isn't brought to the RPi GPIO)
The XBee is a common XBee radio, the SPI stuff is for the Bluetooth Bee.
1 Wire is an option, PWM might be handy.
Comments, questions welcome. Don't like the I/O choices; I'm listening.
Bill

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy