Pages: [1]   Go Down
Author Topic: New guy with a question about USB  (Read 181 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi everyone.  I tried to search for the solution to my question and came up with no answers.  I just bought the Seeed Studio protoshield, and it came with a USB B port to solder on.  I really don't like the USB B setup, and I have a standard USB A port sitting around the office not being used.  Is there anyway to use the USB A port instead of the B?  I would really appreciate any input.
Logged

UK
Offline Offline
Faraday Member
**
Karma: 92
Posts: 3969
Where is your SSCCE?!?!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

USB B and USB A are used in very different situations.

USB B is to be only on a peripheral.

USB A is to be only on a host.

What are you thinking of using the USB port for?  Actual USB traffic?  Then you have to use the right kind of socket for the end that you are creating.  If you are creating a USB device, then you have to use a USB B connector.  If you are creating a USB host, then you have to use a USB A connector.

If, however, you're just using it for connecting things like sensors, etc, as a generic connection interface, then you can use whatever connector you like.
Logged

Why not visit my eBay shop? http://stores.ebay.co.uk/Majenko-Technologies
Replacement for the Arduino IDE: UECIDE - Proper serial terminal, graphing facilities, plugins, overhauled internals.
Java isn't bad in itself, but it has enabled morons to write programs.

Pages: [1]   Go Up
Jump to: