Go Down

Topic: connect arduino mega 2560 to arduino uno rev 3 (Read 570 times) previous topic - next topic


Hello everyone! Is it possible to connect arduino mega 2560 to arduino uno rev 3? Let us say I am going to use mega as the main controller. If yes, I wish you can tell me how. Thank you


However you want. I prefer serial, but there is always SPI or two-wire interface. Actually communicating is up to you. 8^)


Can be simpler too - just writing an output pin hi or low. Evertytime the Uno sees the pin change it does something,
Really depends what you want the Uno to do.
If its more complex, like turn on LED #4 for 7 seconds, then some form of serial comm's would  be good - UART, SPI, I2C, software serial.
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131