Pages: [1]   Go Down
Author Topic: connect arduino mega 2560 to arduino uno rev 3  (Read 345 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello everyone! Is it possible to connect arduino mega 2560 to arduino uno rev 3? Let us say I am going to use mega as the main controller. If yes, I wish you can tell me how. Thank you
Logged

Offline Offline
Edison Member
*
Karma: 18
Posts: 1171
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

However you want. I prefer serial, but there is always SPI or two-wire interface. Actually communicating is up to you. 8^)
Logged

Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 441
Posts: 23834
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Can be simpler too - just writing an output pin hi or low. Evertytime the Uno sees the pin change it does something,
Really depends what you want the Uno to do.
If its more complex, like turn on LED #4 for 7 seconds, then some form of serial comm's would  be good - UART, SPI, I2C, software serial.
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Pages: [1]   Go Up
Jump to: