Pages: 1 2 [3]   Go Down
Author Topic: Driving A 10x10x10 RGB Cube  (Read 3719 times)
0 Members and 1 Guest are viewing this topic.
the land of sun+snow
Offline Offline
Faraday Member
**
Karma: 159
Posts: 2916
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

For background reference, I happened to chance upon this website,

http://channel9.msdn.com/Tags/electronics/RSS

This video shows pretty good POV,

http://www.youtube.com/watch?feature=player_embedded&v=GUcX41pokZY
Logged

Valencia, Spain
Offline Offline
Faraday Member
**
Karma: 150
Posts: 5661
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
I'm planning to use an external flash chip
Isn't flash slow?

For writing? Maybe...

For reading? My datasheet says the chips accept 66mHz SPI clock during reads - far higher then anything an Arduino can manage!

(OTOH if you've got 19 TLC5940s to drive with SPI there might not be much SPI bandwidth left over...)
« Last Edit: November 17, 2012, 04:06:24 pm by fungus » Logged

No, I don't answer questions sent in private messages (but I do accept thank-you notes...)

Pages: 1 2 [3]   Go Up
Jump to: