Pages: [1]   Go Down
Author Topic: Arduino Xbee Remote Control Aircraft  (Read 1291 times)
0 Members and 1 Guest are viewing this topic.
New Zealand
Offline Offline
Karma: 0
Posts: 9
Lead Programmer @ Lincoln University
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Progress with Arduino Xbee remote control

This project has been in development for a few months, its the third generation of the project and Arduino is the king for simplicity and performance. And it flew on the plane which is proof of the pudding as gran would to say.

The receiver board as flown

The transmitter box

Some practical advise using Xbee

Here is my simple cod the RX now has stability compensation Gyro's so it is mofre complex than the maiden flight code, nevertheless its really simple. I like these Arduino devices but could use 2 serial ports on the Uno form factor board.

My tricopter will be the next aircraft to get the Arduino treatment

* Yellow_Plane_RX.ino (12.66 KB - downloaded 13 times.)
* Simple_TX.ino (5.56 KB - downloaded 15 times.)

Pages: [1]   Go Up
Jump to: