Go Down

Topic: IR Servo project (Read 859 times) previous topic - next topic


The purpose of my project is to control motor from ir remote.
For this I modified servo (to 360 deg) and use IR receiver.

Everything I connected to andruino and it works, but when I move atmega to pcb I'm expecting strange behavior: servo works and changes direction according to my commends from ir remote and after couple changes it stops. When i reset device (cut of power and plug in again) it starts and work properly till it stops again.
Im fighting with it for couple days and I don't have much experience in electronics (in fact it is my first project)
Below it is schema of my connections.

Maybe somebody with experience could give me some tip?


The schematic looks fine.  How about posting the code and possibly some clear pictures of the PCB/soldering?
Facts just don't care if you ignore them.


Nov 17, 2012, 10:39 pm Last Edit: Nov 17, 2012, 10:41 pm by Erni Reason: 1
Maybe a 10 Kohm resistor from reset to Vcc, and a 100 nF capacitor from Vcc to Gnd


Nov 17, 2012, 10:52 pm Last Edit: Nov 18, 2012, 04:15 pm by BillO Reason: 1
Yes, if they are not already done, they are a must.  I guess I should never assume.
Facts just don't care if you ignore them.


You are great.

I added this two elements and everythink works like a charm.

Here I added schema and images for if somebody will be interested in this topic in future.


Thanks again.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131