Go Down

Topic: How do I make the arduino uno put out more power? (Read 585 times) previous topic - next topic


I am working on a project with the arduino uno and I need it to open and close a 24 volt valve, but the board only puts out 5Vdc and isnt strong enough to open the valve. How would I make the arduino put out more power?


solid state relay is the easiest, one with a 5 volt input and an output that handles 24vdc and the required current (its quite common as many industrial machines use this setup)


The problem is not so much the volts but the current!
An Arduino pin can only source an absolute maximum of 40 mA, far less than your valve will probably draw.

You need to have an external powersupply and control the valve inderectly via a powertransitor or a solid state relay.

Some good reading:



Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131