Did you try the 3.3v pin on the arduino?
A 27R on the base is far too small make it a 2K7 at least. Are you trying to control the power to this device or send a signal to it?If a signal then :-Then on the collector you need a pull up resistor, say 1K to the 3V line.
Did i get something wrong?
QuoteDid i get something wrong?Maybe. Where did the 1.3 and 0.05 come from?
I used a 27 resistance since i used the ohm law: 1,3/0.05 = 27?Did i get something wrong?
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16