Go Down

Topic: High Power LEDS Arduino controlled (Read 2690 times) previous topic - next topic

Siberio

Ok, I'll do my researches.
But I need to ask one thing more: if I wanted to use AC/DC drivers, directly wired to 240 VAC, all in parallel and 1 for every led, would also the drivers need a heat sink?
If doing so, I would use relay modules instead of mosfets.

Grumpy_Mike

That sounds an expensive way of going about things. However, it is unlikely that you would need a heat sink because most ready built modules are built with enough built in heat sinking as to not require any extra.

Siberio

I know setting up some series would help me save some money, but since I plan to "sell" some devices like this, I cannot afford the possibility to have one series of led not lighting up because only 1 may fail.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy