Go Down

Topic: Driving 4 LEDs and 4 Relays with a ULN2803? (Read 1 time) previous topic - next topic


Any thoughts on problems driving (sinking) 4 LEDs on the 5V rail and 4 Relays on the 12V rail with the same ULN2803? (diode clamp on 12V rail)


Since the 5V and 12V supplies go to the same Ground there should be no problem sinking either or both.
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e


Yup, the diodes only needed on the relay windings so that should be fine.  Don't forget current-limiting resistors for the LEDs.
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131