Do you happen to know why this happens?
I'm not using any pull-up resistors also. Should I ?
2k2 means 2.2 kOhm and 4k7 means 4.7 kOhm. The bus capacity is added up from the capacities of the connected devices plus a bit for the bus cables. If you don't have the capacity per meter cable of the wires you use, guess it from a similar cable. Usually it's a few pF per dm. If you have a scope you don't have to calculate the bus capacity, you can simply try different resistor values and have a look at the changes of the signal picture.In your case I would try with 2k2, this probably fits your needs.
Thank you. Is this how I should connect the resistors?
Should the GND of the compass be connected to Arduino's GND in order to work as a slave device, just like with the slave Arduino? Cause currently I have it on the GND of the circuit.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16