Go Down

Topic: Arduino Mega 2560 Bootloader issues (Read 549 times) previous topic - next topic

hc08jb8

Hello

I have got a Arduino Mega 2560 and I am having difficulty uploading sketches to it, the uploading seems to be a bit erratic where after compiling and if I do a reset on the Mega board the upload is fine, else it times out.

I have tried the following:-

I am using the latest Arduino 1.0.2

1. Reflash the bootloader hex from the Arduino folder using  AVRISPmkII via AVR Studio 6
2. Rest board and PIN13 LED blinks upon boot
3. Send 3 !!! via a terminal client and the serial monitor shows up
4. Verified that the programming protocol is set to wiring in Arduino software

Despite these, when I try to use the Ardunino software to program the Mega board using USB cable, it timeouts and only programs if I manage to press the reset button on a specific time.

Any ideas whats going wrong? Could someone point me in the right direction to resolve this?

Thanks
Jay


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy