Pages: [1]   Go Down
Author Topic: Aduino MEGA 2560 + Eternet shield / SPI communication  (Read 335 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Dears,

I am using an arduino mega 2560 + ethernet shield. It is working fine from a network point of view. But I noticed that DIGITAL PIN 51 is always HIGH. Even if I write it low.
I read that such pin 51 is used for SPI communication. Does it explain the HIGH level on pin 51 ? Is there a workaround ?

Thanks for your answer.

Florent
Logged

Miramar Beach, Florida
Offline Offline
Faraday Member
**
Karma: 144
Posts: 5974
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

You must leave pins 50-53 alone. Those are used by the SPI bus.
Logged

Pages: [1]   Go Up
Jump to: