Pages: 1 [2]   Go Down
Author Topic: Reading central heating system thermistor's?  (Read 1868 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Full Member
***
Karma: 0
Posts: 106
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Ups, i did forged the attachment in the last posting.
I think i need more sleep  smiley-sleep


* temps.GIF (26.54 KB, 1415x1000 - viewed 9 times.)
Logged

United Kingdom
Offline Offline
Tesla Member
***
Karma: 224
Posts: 6613
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Two problems:

1. You have the output of the MAX6145 shorted to ground.

2. Pin 1 of IC2 needs to be driven low by the same signal that drives the CS input of ADC low. You are using Voa to drive CS low. So you need to connect pin 1 of IC2 to Via of the ADUM6401, not to Vic. Alternatively, swap the ADUM6401 channels around.
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Offline Offline
Full Member
***
Karma: 0
Posts: 106
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I thought the Arduino SCK (D52) must be routed to SCK of the MCP3204?
If i swap them "Arduinos SCK" goes to "CS of MCP3204" and "CLK of MCP3204" to a digital pin of the Arduino?
Logged

United Kingdom
Offline Offline
Tesla Member
***
Karma: 224
Posts: 6613
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I thought the Arduino SCK (D52) must be routed to SCK of the MCP3204?
If i swap them "Arduinos SCK" goes to "CS of MCP3204" and "CLK of MCP3204" to a digital pin of the Arduino?

Correct; so if you swap the ADUM6401 inputs around, you must swap the outputs in a similar way. However, pin 1 of the 74LV125 must be controlled by the same signal that controls CS on the ADC.
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Offline Offline
Full Member
***
Karma: 0
Posts: 106
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I just want to let you know that i already have some parts but not all and
that i also need to figure out some other stuff.
I will build it - not that you think your efforts on teaching me this was to no avail
Logged

United Kingdom
Offline Offline
Tesla Member
***
Karma: 224
Posts: 6613
Hofstadter's Law: It always takes longer than you expect, even when you take into account Hofstadter's Law.
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thanks, and good luck!
Logged

Formal verification of safety-critical software, software development, and electronic design and prototyping. See http://www.eschertech.com. Please do not ask for unpaid help via PM, use the forum.

Pages: 1 [2]   Go Up
Jump to: