Loading...
« previous topic   next topic »
Pages: 1 [2]   Go Down
Author Topic: Voltage fluctuating too much. How to fix?  (Read 861 times)
0 Members and 1 Guest are viewing this topic.
hfp777
Offline Offline
Full Member
***
Karma: 0
Posts: 118
View Profile
« Reply #15 on: November 21, 2012, 06:53:27 pm »
 Bigger Bigger Smaller Smaller Reset Reset
I was thinking that maybe I should make a separate power line for the buzzer and the LCD backlight as they are drawing too much current? Or maybe put the two sensors on their own 5V regulator and all the rest on a separate 5V regulator?
Logged
I am a total amateur at electronics and all things related. I have no education in the matter other than self taught.

Please factor this in your answer and clarify as much as possible. It will help me understand better and will help people like me googling this answer/solution.

hfp777
Offline Offline
Full Member
***
Karma: 0
Posts: 118
View Profile
« Reply #16 on: November 22, 2012, 10:27:36 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Would that solve the problem? What about the ground lines, does it matter if I power the sensors from a separate 5V regulator but ground them to the Arduino's pin?
Logged
I am a total amateur at electronics and all things related. I have no education in the matter other than self taught.

Please factor this in your answer and clarify as much as possible. It will help me understand better and will help people like me googling this answer/solution.

Pages: 1 [2]   Go Up
Print
« previous topic   next topic »
 
Jump to: