Go Down

Topic: Noise in audio if I feed audio (PWM output from an audio module) to mic (Read 1 time) previous topic - next topic


I am feeding audio from a Sound module wtv020sd-mini which is PWM , to the mic Pins of My GSM Module Sim900, when I hear this sound on a a speaker although its not a high quality still its fair enough, but when I play the same voice and feed it to Sim900 mic and listen to it over a call its quality is very poor, there are alot of humming sounds and voice quality itself is also low.

I wanna use the module for voice response to callers , Is it all because of PWM output ? I used another module from ISD17150 and its voice quality is very nice even on the call.


That link is bad.

So I am unsure what you mean by "which is PWM"
It is unlikely that the output is actually PWM.

but when I play the same voice and feed it to Sim900 mic

Again it is not clear what you are doing. You seem to be saying that you are feeding a sound signal into a microphone and using it as a speaker. Surly that is not what you are doing?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131