I hope this isn't considered as crossposting, I already posted my problem to the German speaking section of the board. If so, I am sorry for that.
I am stuck since days on a problem with my ATmega 8.
I want to burn the bootloader to it, using the Arduino Uno V3 as a programmer. So, I first uploaded the ArduinoISP sketch, then chose Arduino as ISP, changed the board to Arduino NG with ATmega 8, connected the ATmega 8 on a breadboard to the right connections (The AT 8 is wired correctly with a 16 MHz Crystal), then clicked on Burn Bootloader. My problem is, I get an error message instantly from AVRdude. After clicking on Burn bootloader for a second time, it takes a while untill I get another error message.
I read that you need to use a 220 Ohm Resistor from reset to 5V, but only on a Arduino Duemilanove, but I'm using an Arduino Uno REV 3. I once programmed an ATtiny 45 which needed a 10uF electrolytic capacitor from reset to ground, so I did this aswell, but it didn't help - Still the same Error messages.
I don't know what to do, I tried everything but I can't get the bootloader on the ATmega 8
Thanks in Advance!