a few tips:1) power it up for the first time through a 100ohm resistor, and measure the voltage over that resistor: this assures you if there is short.2) you need to make sure that the dc working points are correct. Measure voltage on Q1's b / c, Q2's b/e/c, Q3's b/e. and compare them to what you expect. For example, Q1's b should be about 0.7v, Q2's b should float with RV2, etc.3) if you have a scope, it would be helpful but get the dc working points and report back.
1) no idea what "led" you are talking about.2) the voltage I was talking about was the respective points vs. ground.
You need to raise RV2's wiper so that Q2's vbe goes towards 0.6-0.7v and Q3's base goes above 0.7v.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16