Go Down

Topic: How do I configure Ethernet shield to be used in Cosm? (Read 1 time) previous topic - next topic

vmandin

I have seen the code from COsm. But dont know how to configure the IP and mac, what should I do? What part in the code should I edit?
Im using the Wiznet W5100 ethernet shield and arduino uno. I can seem to establish connection.

Pls help.

A step by step tutorial will do. Esp in editing the code provided. Im new with arduino ethernet and stuff. pls

NickPyner

If you have established the connection OK, which should be very evident, I think you have done all you can with your code, and the problem is now configuring the cosm end. The introductory email form cosm has all you need. The configuration is done on your cosm console. Your logon to cosm takes you to your console.

I had a bad time with cosm but I got it together when I used their new libraries

Cosm.h

HttpClient.h

If you have not already done so, it might be good idea to get them. I don't use the IP address, just the mac.

PaulS

Quote
A step by step tutorial will do. Esp in editing the code provided. Im new with arduino ethernet and stuff.

"I jumped into the deep end of the pool. Can you provide a link to a tutorial to teach me how to swim?"


robtillaart


AT the cosm site there is a tutorial with arduino code IIRC
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

robtillaart

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

NickPyner


Go Up