Go Down

Topic: Help with RPM code (Read 4489 times) previous topic - next topic


SAButter

Did you check to see what the voltage at that point is in each state?

Krupski



Yes I did get one of the 3 wire fans yesterday to test the code and it worked fine, got about 2400rpm.  I also built a new IR rpm sensor instead of using the photo-interrupter, It still gave me wrong numbers.

Here is the circuit I used:


I have seen other people make these circuits so why is not working for me. What is wrong?


THAT diagram is correct (finally!)  :)

Have you looked at the signal with an oscilloscope? Maybe you are getting 120 hz "interference" from fluorescent lighting.

Gentlemen may prefer Blondes, but Real Men prefer Redheads!

Epek

i have a same problems, did this problem had been solved? thanks

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy