Go Down

Topic: Arduino MEGA 2560 R2 getting hot in few seconds (Read 719 times) previous topic - next topic

harinath

Nov 28, 2012, 04:58 am Last Edit: Nov 28, 2012, 05:02 am by harinath Reason: 1
Hello arduino tech support,

Arduino MEGA 2560 R2 getting hot in few seconds after plugging USB or AC-DC power adapter.
The microcontroller is getting hot then the heat spreading entire board. Nothing connected to board.
First , When the board connected via USB, drivers installed & board recognized by PC. Getting hot.
Next, I disconnected USB & connected power(center-positive plug) from AC-DC adapter(8.75 V). It is getting hot as usual.
Don't know what to do ?

We bought this board in South Korea. Letters on board shows "MADE IN ITALY".

spycatcher2k

Hi - If you did not buy it from a reseller - it's probably a clone - I've seen this way to many times - Faulty Mega2560 chips, solder bridges, unreliable caps & resisters. Better to get an Official one - They cost a little more, but there tend to be a very few issues with them. and official distributors will tend to replace them if sold faulty.
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

harinath

I bought it long time ago from http://artrobot.co.kr/. Due to some other project works, i did not test it just after arrival. Now this is the problem. check out this website has dealership for Arduino official hardware.

CrossRoads

Usually a chip that gets really hot has damaged IO pins, and is just a matter of time until total failure (unless it has already).
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy