Low Crosstalk Between Switches: ?50 dBTypical at fis = 8 MHz, RL = 1 k?
Frequency Response, Switch On = 40 MHzTypical
The resistor is 47 ohm, the capacitor is 10 nF
Now with arduino duemilanove I'm working @ 10 khz but in future I will arrive at 1 mhz or more, so don't know if this is the right switch design for HF.
A 3rd approach would be to use a memory device pre-programmed with your waveform as your own dds.
Those are really the great-grandfather of today's cpld/fpga. Parallel eeprom and parallel sram are still available today, albeit hard to find.
For higher frequency I suggest you use a proper DAC rather than your home-made one. If you only want sine wave output then try this http://www.ebay.co.uk/itm/New-AD9850-DDS-Signal-Generator-Module-0-40MHz-Test-Equipment-/180820399452?pt=UK_BOI_Electrical_Test_Measurement_Equipment_ET&hash=item2a19bc555c.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16