Pages: [1]   Go Down
Author Topic: Web interface for equipment status?  (Read 308 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 24
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all,

I have been working on a remote temperature and voltage monitoring device, featuring Arduino, GSM Cellular Shield (SM5100b).  I have no problems in the monitoring side.  However, instead of sending SMS (status reporting) to my mobile i want the GSM Cellular Shield to send it to another Cellular Shield which is located somewhere in the office, and at the same time it updates the status to the internet by Arduino Ethernet shield.  My question is : is it feasible to do so in the receiver side? smiley-small  As always any help, tips will be welcomed. Thank you in advance!! smiley

Regards,
Logged

Brisbane, Australia
Offline Offline
Edison Member
*
Karma: 33
Posts: 1121
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

My question is : is it feasible to do so in the receiver side?
What is it you want to do with the receiver end?

Geoff
Logged

"There is no problem so bad you can't make it worse"
- retired astronaut Chris Hadfield

Georgia, USA
Offline Offline
Jr. Member
**
Karma: 0
Posts: 80
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i want the GSM Cellular Shield to send it to another Cellular Shield which is located somewhere in the office, and at the same time it updates the status to the internet by Arduino Ethernet shield. 
So you have one Arduino device with a GSM Cellular Shield talking with a second one.  Got that but are you saying the second one also has a Ethernet shield on it?  Do you have enough program space to support both?

Jim.
Logged

Pages: [1]   Go Up
Jump to: