Go Down

Topic: WIFI Shield Status is always WL_NO_SHIELD (Read 2382 times) previous topic - next topic

dwkd

Hello all,
I am new to Arduino and right off the bat I encoutered an issue with the Wifi shield acting as it's not being present.
The board I have is a OSEPP Mega 2560 which is similar to Arduino Mega 2560. As seen in the pic, I have an original Arduino Wireless Proto Shield connected and an Xbee.
The code uploaded is pretty simple.
Basically, if there's a Wifi status other than WL_NO_SHIELD light up my green LED otherwise light up the red one.
Reading online I found that some people experience this due to not having enough power from the USB so I've even connected this to a 12v and still no luck.

Code: [Select]

#include <WiFi.h>

char ssid[] = "mySSID";
char pwd[] = "myPW";

void setup(){
  pinMode(12, OUTPUT);
  pinMode(52, OUTPUT);
  WiFi.begin(ssid, pwd);
  Serial.begin(9600);
 
}

void loo
  if (WiFi.status() == WL_NO_SHIELD) {
    digitalWrite(52, HIGH);
    digitalWrite(12, LOW);
  } else {
    digitalWrite(12, HIGH);
    digitalWrite(52, LOW);
  }
 
}




pitusso

#2
Nov 30, 2012, 02:35 pm Last Edit: Nov 30, 2012, 02:39 pm by pitusso Reason: 1
I, maybe i'm wrong, but the wifi library works only with the Wifi Shield (IEEE 802.11), not with the radio wireless  :P
Take a look at:
http://arduino.cc/en/Main/ArduinoWirelessShield

dwkd

#3
Nov 30, 2012, 08:03 pm Last Edit: Dec 06, 2012, 03:13 am by dwkd Reason: 1
So the proto shield is for communication between xbees and does not have the capability to pickup and connect to a wireless network?

dwkd


Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy