Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: ADXL193: ST pin?  (Read 157 times)
0 Members and 1 Guest are viewing this topic.
Stan09
USA, OH
Offline Offline
Jr. Member
**
Karma: 0
Posts: 54
View Profile
« on: December 03, 2012, 02:20:47 pm »
 Bigger Bigger Smaller Smaller Reset Reset
I can't figure out from datasheet how I should connect ST pin?
I need no self-test, just for regular reading from OUT pin?
Should I ground ST or just leave it hanging?
Logged

dc42
United Kingdom
Offline Offline
Faraday Member
**
Karma: 130
Posts: 4644
View Profile
WWW
« Reply #1 on: December 03, 2012, 07:50:20 pm »
 Bigger Bigger Smaller Smaller Reset Reset
You can do either - the ST pin has an internal pulldown resistor to ground. Ground it if you think it is picking up interference.
Logged
Formal verification of safety-critical software, software development, and electronic design and prototyping. http://www.eschertech.com

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: