Pages: [1]   Go Down
Author Topic: how to extract data from i button DS1923-F5# using arduino  (Read 709 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 38
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,


I am trying to get the data from DS1923-F5# using arduino. I have an sample code to extract data from DS1920-F5 using the same code while changing the vlaues of the registers for DS1923-F5# is not working out. So please let me know how to do it as DS1923-F5# is a Temperature/Humidity Logger ibutton where as  DS1920-F5 is just the Temperature i button.

Thank you
Logged

Sussex UK / CT USA
Offline Offline
Edison Member
*
Karma: 0
Posts: 1028
Forums forever
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

If no one has already invented this wheel... which you should hope for!... there's LOTS (not for the faint hearted) on 1-Wire stuff, reading the datasheets, etc, at....

http://www.arunet.co.uk/tkboyd/e1didx.htm

and

http://www.arunet.co.uk/tkboyd/e1dsw.htm

Be of good cheer! You can probably, for Arduino work, skip over all of the "addressing"/ "selecting" stuff covered in the pages mentioned above.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 38
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I have gone through the links that were stated in the post but i didn't find any example which can extract data from the ibutton logger. Can you please post any example that will get the data from ibutton logger.

Thank you
Logged

Pages: [1]   Go Up
Jump to: