Go Down

Topic: work maxbotix EZ-1 sensors with arduino (Read 615 times) previous topic - next topic

Hello ;

I m planing to make mini sumo robot and ?'ll use maxbotix ez-1 ultrasonik sensor(6 piece). How can ? connect to sensors with arduino card( for gnd pin and +5v pin). Should i make different card and connect to this card ?

Thanks for advance.

AWOL

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

oric_dan

That's very good. Who knew it was so easy to manipulate the MCP.
[MCP reflects back to Tron, in case of confusion].

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy