Pages: [1]   Go Down
Author Topic: work maxbotix EZ-1 sensors with arduino  (Read 551 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello ;

I m planing to make mini sumo robot and ı'll use maxbotix ez-1 ultrasonik sensor(6 piece). How can ı connect to sensors with arduino card( for gnd pin and +5v pin). Should i make different card and connect to this card ?

Thanks for advance.
Logged

Global Moderator
UK
Offline Offline
Brattain Member
*****
Karma: 310
Posts: 26634
I don't think you connected the grounds, Dave.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Try here
Logged

"Pete, it's a fool looks for logic in the chambers of the human heart." Ulysses Everett McGill.
Do not send technical questions via personal messaging - they will be ignored.

the land of sun+snow
Offline Offline
Faraday Member
**
Karma: 159
Posts: 2927
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

That's very good. Who knew it was so easy to manipulate the MCP.
[MCP reflects back to Tron, in case of confusion].
Logged

Pages: [1]   Go Up
Jump to: